Dry soil mixing is a ground improvement technique that improves soft, high moisture clays, peats, and other weak soils, by mechanically mixing them with dry cementitious binder.

Dry soil mixing technique image

Common uses

Applicable in soils that have a high moisture content, and often used in high groundwater conditions, to allow chemical reaction of the soil and groundwater with stabilising binders injected in dry form
Increase bearing capacity
Decrease settlement
Mitigate liquefaction
Fix contaminants in situ
Increase site global stability

Process

To construct the columns, a high-speed drill advances a drill rod with radial mixing paddles near the bottom of the drill string into the ground. During penetration, the tool shears the soils to prepare them for mixing. After the tool reaches the design depth, the binder is pumped pneumatically through the drill string to the tool, where it is mixed with the soil as the tool is withdrawn.

The dry soil mixing process constructs individual columns, rows of overlapping columns, or 100% mass stabilisation, all with a designed strength and stiffness.

Specialist Contact | Nigel Matthews - nigel.matthews@keller.com - +44 (0)7918 905057

Advantages

Quiet and vibration free
Environmentally-friendly as uses readily available materials
Almost no spoil
Operations can be done at low temperatures
Can replace more expensive deep foundation methods
Flexible in application
Reduces construction time

Quality assurance

Quality is controlled and assured through column installation protocols and the results of laboratory and field-verification tests. Each column is provided with a chart-log, which typically comprises: column number, mixing tool details, mixing depth, mixing time, slurry specification, injection flow rate and pressure, total volume of slurry used, mixing tool velocities and rpm during penetration and withdrawal and torque of the shaft.

The mixing energy and binder content is calculated from this information to match design requirements.

Specimens of stabilised soils for testing are usually obtained from fresh columns with a wet grab.

Advanced core drilling and other field-testing methods can also be used to obtain specimens and to inspect the continuity, uniformity and stiffness of deep soil mixing columns. The selection of suitable verification methods depends on their relevance, accuracy and applicability in relation to the purpose and pattern of soil treatment and design properties of stabilised soil.